DAPAudio IEM-100 Beltpack, Product Manual

Page: 9 / 17

7
 Equalizer Setting:
Press the
SET button until EQ is flashing (Figure 12). Use the Up or Down button to adjust the Audio
Balance.
Fig. 8
Note: If no button is pressed for 3 seconds, the system will automaticly exit the setting state and
save the current setting.
Receiver Functions
1. Limiter function;
If the limiter is switched on, the volume will corrected automatically if the value rises above the set
threshold. This in order to avoid distortion and protect your ears.
2. Equalizer setting:
Treble boost 6dB
Bass boost 6dB
Bass + treble boost 6dB
Flat
Fig. 9
3. Squelch setting:
If the RF signal is less then the squelch setting. The signal indicator will dim and the audio output
will be muted.
Mix Mode/ Stereo Control
The receiver receives two signals (1/L and 2/R) from the transmitter and then processes these signals in
either mix or stero mode.
Stereo Mode
In stereo mode the signals remain separate so that 1/L is heard through the left headphone and 2/R is
heard through the right headphone. The balance knob on the receiver can be used to adjust the
balance between the left and right headphones. See Figure 14.
Fig. 10