DAPAudio DS-UMP1, Manual

Page: 14 / 16

12
12. Reloop
1. If you press the Reloop button, the DS-UMP1 starts at the last selected loop.
2. Press the button over and over rapidly to start the loop again and again.
3. Press one of the Loop buttons again, the loop play function is canceled, the Loop indicator
dimms.
13. Repeat
1. Press the Repeat button once to repeat the current track The display shows “1”.
2. Press the Repeat button again to repeat the whole folder. The display shows “F”.
3. Press the Repeat button again to repeat the whole USB stick or SD card. The display shows “A”
4. Press the Repeat button a fourth time, to exit the Repeat Mode.
Maintenance
The DAP DS-UMP1 requires almost no maintenance. However, you should keep the unit clean. Disconnect
the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in liquid. Do not
use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the audio connections with a damp
cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Troubleshooting
DAP DS-UMP1
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
1. If the device does not operate properly, unplug the device.
2. Check power from the wall, all cables, connections, etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If nothing happens after 30 seconds, unplug the device.
5. Return the device to your DAP Audio dealer.