8
Installation
Remove all packing materials from the CD Player. Check that all foam and plastic padding is removed..
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. The power supply is printed on the back of the device.
Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connections
1.
Turn off the POWER switch.
2.
Use RCA cables to connect the Line out outputs to a line input on your mixer.
Functions
NAMES AND FUNCTIONS
Below is a description of the functions of the controls.
CD-player Functions
1. Power LED
Indicates that the DS-UMP1 is switched on.
2. Power ON/OFF
This is the main power
switch. Press to turn the device on.
3. Mic
Electronically balanced XLR-type input for connecting a low-impedance microphone.
4. Mic Gain
Use this control to match the connected microphones optimally to your audio signal.
5. SD Card-slot
Slot for inserting SD/MMC card. The contacts of the card must point downwards. The unit cannot read
cards with a capacity of more than 4GB. The unit is not compatible to SDHC cards and only supports
the MP3 format.
6. USB-slot
Allows the connection of any USB memory stick.
7. Phone
You can connect a pair of headphones with an impedance of 32 - 600 Ohm to the headphones
connector. It is a 6,3mm/
1
/4” TRS socket, wired as Tip=left, Ring=right and sleeve = ground.
Caution:
Depending on the type of headphones connected to the Headphones jack, the DS-UMP1
is capable of producing high output levels via the phones output. Therefore, make sure to turn the
control all the way to the left (minimum setting) before connecting the headphones. Be aware of the
fact that listening to loud sound pressure levels over a longer period of time leads to hearing damage!
8.
LCD Display
9. SD LED
When lit, the
SD slot (5)
is selected.
10/ 33.
SD/
USB button
Use this button to switch between
SD
slot (5)
or
USB slot
(6)
. Selection is indicated by the
SD LED (9)
or the
USB LED
(20).
12/ 37. Cue:
Press this button during playback to return to the position at which playback is started.
13/ 41.
Loop IN:
Press this button to set the startpoint of the loop.
14/ 42.
Loop OUT:
Press this button to set the endpoint of the loop.
Summary of Contents for DS-UMP1
Page 1: ...DS UMP1 ORDERCODE D1129...
Page 16: ...2009 DapAudio...