8
Installation
Remove all packing materials from the Turntable. Check that all foam and plastic padding is removed.
Before use, check for the following parts included in the package with the main unit: Turntable Platter,
Slip mat, 45-rpm adapter, Counterweight, Headshell.
Assembly of the Turntable :
1. Save packaging for future transporting or shipping.
2. Set the 45-rpm adapter on the main unit.
3. Set the turntable platter onto the center spindle.
(a) Attach the rubber belt to the motor as shown in Figure 3 below.
Fig. 3
VERY IMPORTANT!!
- Do not forget to attach the rubber belt to the motor for correct operation. After
placing the turntable platter onto the turntable through the center spindle, move one of the large
windows on the Platter to the top right corner. Attach the rubber belt* around the motor (see fig.3).
(*Rubber belt is already attached to the underside of the Turntable Platter).
4. Place the slip mat on the platter.
5.
Installation of the cartridge:
When installing a cartridge, refer to the operating instructions supplied by
the manufacturer of that cartridge. During installation, attach the stylus protector to guard the stylus
tip from damage.
(a) Connect the lead wires to the cartridge terminals. The terminals of most cartridges are color-
coded.
Connect each lead wire to the terminal of the same color.
WHITE (L+)..............Left
BLUE (L-).....................Left channel-
RED (R+)..............Right
GREEN (R-)..............Right channel-
(b) Install the cartridge to the headshell and tighten it with screws, provided with the cartridge.
6. Insert the headshell into the front end of the tonearm, then turn the lock nut counterclockwise with
The headshell firmly held horizontally.
7. Slide the counterweight onto the tonearm, Twist it lightly and it will screw onto the rear shaft of the
tonearm.
Summary of Contents for DS-TT-750-USB
Page 1: ...DS TT 750 USB ORDERCODE D1209 ...
Page 17: ...2009 DapAudio ...
