DAPAudio DS-380TL, Manual

Page: 12 / 14

10
3) Turn the Shuttle wheel
• Turn the Shuttle wheel clockwise during play to increase the BPM in the forward direction,
counterclockwise to decrease the BPM. The faster you turn the wheel, the more BPM changes.
The BPM changes with a range of+/-12%.
• When you release the Shuttle wheel, the CD will return to the BPM indicated by the pitch slider.
15. Program Play
1. Press the PROG button, the player will enter the program mode and the CD will stop rotating.
2. Select the desired track by pressing the SKIP button, then press the PROGRAM button again. The
selected track will be added to the program sequence.
3. Repeat step 2. A maximum of 30 tracks can be programmed.
4. Press the PLAY/PAUSE button to start the program play from the first selection.
5. Press the program button again during program play to stop playing.
6. Press and hold the program button more than 2 seconds to cancel the program mode and erase
All the current program contents.
16. Loop PLAY
1. Press LOOP IN button to set the loop start point, the LOOP indicator will flash on the LCD.
2. Press LOOP OUT button to set the loop end point. After the end point is set, the playback will
enter the loop play from start point to end point repeatedly.
3. Press one of the LOOP buttons again, the loop play function is canceled, the LOOP indicator
dimms.
17. Reloop
1. If you press the Reloop button, the disc will go back to the last selected loop.
2. Press the button over and over rapidly to start the loop again and again.
3. Press one of the LOOP buttons again, the loop play function is canceled, the LOOP indicator
dimms.
18. Repeat
1. Press the Repeat-button once to repeat the current track.
2. Press the button again to repeat the whole disc.
3. Press the button a third time, to exit the Repeat Mode.
Before switching off the power
When you have finished using the CD player, before switching off the power, be sure that the disc holder
has been closed with the OPEN/CLOSE button.
CAUTION: Do not forcibly close the disc holder when the power is off.
Do not switch off the power, when the disc holder is open.
Switch off the power after the disc holder has been closed with the OPEN/CLOSE button.
CD’s
Precautions on handling compact discs
• Do not allow fingerprints, oil or dust to get on the surface of the disc. If the disc is dirty, wipe it off with a
soft dry cloth.
• Do not use thinner, water, record spray, electrostatic-proof chemicals, or silicone-treated cloths
to clean discs.
• Always handle discs carefully to prevent damaging the surface; in particular when removing a disc
from its case or returning it.
• Do not bend the disc.
• Do not put the CD near heating sources.
• Do not enlarge the hole in the center of the disc.
• Do not write on the label (printed side) with a hard-tipped implement such as a pencil or ball point pen.
• Condensation will form if a disc is brought into a warm area from a colder one, such as outdoors in
winter. Do not attempt to dry the disc with a hair dryer, etc.