DAPAudio DCL-2, Manual

Page: 8 / 16

6
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Install this device on a flat surface, not bending or curved.
Do not supply power before all components of the system are set up and connected properly.
1. Directly
Selected encoders, for example, RATIO, THRESHOLD and TIME encoders, are adopted for convenient
operation.
Turn encoder 1 to adjust the compression ratio, and
indicates the change of the value.
The adjustment range: 1.00 – Limit
Turn encoder 2 to adjust the compression threshold.
The adjustment range: -61 dB – 0 dB, step: 1 dB
Turn encoder3 first adjust attack time.
The adjustment range: 0 – 350 dB/sec
And press encoder 3 and turn it to adjust hold time.
The adjustment range: 0 –100 ms
Press encoder 3 again and turn it to adjust decay time.
The adjustment range: 0 – 350 dB/sec
Note: Under the mode of MONO Comp = Sub or Two Brand Comp, the channel indicates L&R and Sub. In
this case, three parameters, compression ratio, threshold and time, are adjusted simultaneously for the left
and right channels.