DAPAudio D3902, Manual

Page: 10 / 12

9
Ordercode: D3902
Odin S-218A Ultra Sub
How to Make a Data Cable
A standard ETHERNET cable can be used to replace the data cable required to transmit data.
Please follow the instructions below in order to create an extra net cable.
Take a standard net cable (CAT-5/ 5E /6) and connect it to the RJ45 connector, as shown in the picture
below (Fig. 04). The wires should now be colored as follows:
Fig. 04
Maintenance
The Odin S-218A Ultra Sub requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the connections with a damp cloth.
Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
01)
If the device does not operate properly, unplug the device.
02) Check the fuses, power from the wall, all cables, etc.
03) If all of the above appears to be O.K., plug the unit in again.
04) If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
05) Return the device to your Dap Audio dealer.