5
CX Series
CX-500/900/1500/2100/3000
Functions & Features
2x Channel in and Link out.
2x Speakon out.
Built-in Clip Limiter.
Switchable entrance sensitivity: 0.775V and 1.4V.
Bridge, parallel or stereo mode.
Efficient heat-sink.
Variable speed cooling fan.
Front panel level gain control.
Excellent audio signal performance.
Very little harmonic distortion (THD), intermodulation distortion (SMPTE-IM), transient intermodulation
distortion.
Operation
Installation
Remove all packing materials from the Vision. Check that all foam and plastic padding is removed.
Screw the equipment into a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Install this device on a flat surface, not bending or curved.
Do not supply power before all components of the system are set up and connected properly.
Mode Selection
The three-position, recessed Mode Select switch (located on the rear panel) configures the amplifier for
either Stereo. Parallel or Bridged Mono Mode. Amplifiers are factory-configured for Stereo Mode.
