DAPAudio COM41 HANDHELD, Product Manual

Page: 8 / 16

6
Installation
Remove all packing materials from the Com-41. Check that all foam and plastic padding is removed.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
1. Refer to Figure 4. Connect the supplied power AC adapter into the DC input Connector (9) at the
back of the receiver. Plug the adapter in a wall socket or other AC power source. Push the
POWER switch (1) on the front of the receiver, the red power LED will light.
2. Insert the supplied antennas in the antenna sockets (5, 10) and rotate fully clockwise. Position the
antennas at an angle of 45 degrees.
3. Connect the receiver’s XLR AUDIO OUTPUT (6) to the mixer input using a XLR to XLR audio cable or
connect the receiver’s ¼” JACK OUTPUT CONNECTOR (7) to your amplifiers input using a ¼”phone
plug cable.
4. Slide the transmitter POWER/OFF switch (13) to the power position. The indicator will light for a
moment and the receivers A/B LED’s (2) will light.
5. Talk or sing into the microphone. The AF (3) LED’s intensity will light in relation tothe volume of the
transmitter.
6. Adjust the receiver VOLUME control (4) and the volume adjustement of the connected mixer or
amplifier to a suitable level.
7. If the performance is over, turn off the sound system and slide the transmitter’s POWER/OFF switch
(13) to the off position to conserve battery power.
Front Back
Fig. 4