Page 9
DSP Module Jumper Configuration
Continued
Squelch
Jumper
4
Squelch Enabled
Off
Squelch Disabled
On
Nominal Input Level
Jumper
8
7
6
5
- 8.0 dBm
Off
Off
Off
Off
Reserved
Off
Off
Off
On
Reserved
Off
Off
On
Off
Reserved
Off
Off
On
On
- 2.0 dBm
Off
On
Off
Off
- 3.5 dBm
Off
On
Off
On
- 5.0 dBm
Off
On
On
Off
- 6.5 dBm
Off
On
On
On
- 8.0 dBm
On
Off
Off
Off
- 9.5 dBm
On
Off
Off
On
- 11.0 dBm
On
Off
On
Off
- 12.5 dBm
On
Off
On
On
- 14.0 dBm
On
On
Off
Off
- 15.5 dBm
On
On
Off
On
- 17.0 dBm
On
On
On
Off
- 18.5 dBm
On
On
On
On
Notes:
Factory Default is -8.0 dBm setting
Changes take effect only after Power on Reset
The nominal input level adjustment is used to optimize the performance of the signal
processing algorithms and to maximize signal to noise without overload. Input/output
gain is constant for all settings. The squelch threshold is approximately 24dB below
the nominal input level.
When the DSP-8200d is properly configured, the yellow (normal) led will be on and the
red (overload) led will flash occassionally.
