R
www.danvex.fi
8
INSTALLATION NOTE
Mounting of the dehumidifier on the wall:
9
Step 1: Select the correct position for mounting on the wall, depending on the size of the
holes set and the holes positions of the wall mount bracket. The place of installation should
guarantee the vertical position of the dehumidifier. Mark places for drilling.
Step 2: Use hammer drills to drill holes with depth of 8 ± 0.5 cm Then use the anchor bolts
and install them into the holes with a hammer.
Step 3: Install the wall bracket with anchor bolts in the correct position. Please, provide
secure fixing of the bracket using nuts and washers. Don't forget to hold the bracket in the
correct position during installation.
Step 4: Install the dryer on the wall bracket.
Step 5: Connect the drain hose to the dehumidifier. Turn on the dehumidifier for trial use.
Check the device for presence of abnormal vibration and noise.
Step 6: Installation is finished and the dehumidifier is ready for use.
Installation diagram.
In case of indoor installation of the device, provide availability of free space for its
maintenance. The premises, where the device is installed, must be ventilated.
Before installation of the dehumidifier:
Before shipment from the factory all the dehumidifiers are subject to tests. Unpack the box
and check for damage on the surface of the device, as well as for completeness of
components in accordance with the list specified in the instructions. If You find any damage,
do not attempt to install the humidifier and immediately contact the supplier.
IF DURING TRANSPORT THE DRYER WAS LYING ON THE SIDE, IT NEEDS
TO BE LEFT UPRIGHT FOR AT LEAST 24 HOURS BEFORE THE START OF
ITS OPERATION!!!
(failure to perform this may cause damage to the dryer and void your warranty)
CAUTION
!!!
