Oilburner
Type Gulliver RG0.R
Page 6 of 10
Adjustment
K:\framen\instrukt\Dantherm\RG\Engelsk\RG0r\RG0R.fm-I1-020926-DM/lbk
Fig. 1
Fig. 2
Accessibility to the nozzle:
Remove the burner from the boiler after
loosening the flange anchor nut.
Hook the burner onto the flange (1), loosen
the bolts (3) and remove the blast tube (2)
by rotating (the fitting is bayonet type).
Remove the small cables (4) from the elec-
trodes and the diffuser disc-holder assem-
bly (5) from the nozzleholder assembly
after loosing its fixing screw (3, fig 2).
Screw the nozzle (6) and tighten it as
shown in the figure.
Setting of electrodes:
Install the support diffuser disc (1) on the
nozzle holder (2) and tighten the screw (3)
for further adjustment of the electrode spa-
cing loosen the screw (4) and the electrode
(5) can be moved forward and backwards
until the measurement is correct. If the oil
burner has to run in the highest capacity
(see page one technical data) the diffuser
disc has to be changed. Hereafter adjust
the ignition electrode according to the di-
mensions.
