INSTALLATION
INFORMATION
PLENUM FOR DIRECT AIR DIFFUSION
The appliance
is not ductable
and it is equipped with a delivery plenum fitted with fins that can be
individually adjusted manually.
The fins must be adjusted in such a way that:
▪
they allow for adequate air distribution;
▪
they do not create excessive resistance;
▪
they do not bother people;
To get an optimal air diffusion, we recommend installing the appliance close to a perimeter wall or
in the middle of the room itself, with the air outlet on three or four sides respectively.
▪
In order to avoid dangerous overheating of the appliance, the fins on at least two sides must be
open.
▪
The upper surface of the plenum can not be stepped on.
▪
Air can not be spread from only one side of the plenum.
GENERAL
INFORMATION
ACCESSORIES
Any accessories must be original. To install them, follow the instructions included in the relevant
package.
GENERAL
INFORMATION
PRINCIPLE OF OPERATION
The operating principle is described below:
▪
When the room thermostat detects a temperature lower than the value set, it activates the
burner at a fixed thermal power previously set.
▪
Approx. 1 minute after the flame has been ignited, also the ventilation unit starts, thus releasing
warm air in the room.
▪
When the room thermostat detects that also the second pre-set temperature level has been
reached, it authorises the turn-off of the burner. After approx. 3-4 min. - when the heat
exchanger has completely cooled- the ventilation unit goes off too
P
age
.
16
