12
Additional equipment
The unit is delivered without any accessories mounted . If further functionality is requested
the accessories are to be installed prior to initial unit installation or alternatively after commis-
sioning .
The unit can be equipped with a silencer .
The unit can be equipped with an electrical preheating element that preheats the incoming
air . The preheater increases the outside air temperature going into the heat exchanger, and
thereby reduces the risk of ice in the heat exchanger in very cold conditions .
This unit can be fitted with a VOC (air quality) sensor . This sensor will continuously monitor
the quality of the extract air, and adjust the air flow level accordingly . This operation is named
demand mode . If a HRC remote control is connected, the level will be shown in the display
using 3 level icon .
Using demand mode will result in the correct level of ventilation with lowest possible electri-
cal power consumption .
Adjust the ventilation and keep track of the home’s humidity and temperatures via the
large LCD screen in the hand-held remote control . Enable cooling function/bypass (if this is
installed in the HCV unit), select manual ventilation steps or relevant weekly programs or set
the controls to automatic . The remote control can communicate with the HCV unit at up to 30
metres distance . The remote control can be placed on level surfaces or hung up on the wall .
If the unit is placed in a way, which makes it difficult to reach the control panel, the HCP 10
Home Ventilation Control Panel can be connected to the unit . HCP 10 is connected to the unit
via cable and gives the same functionality as the control panel .
Connect a number of additional accessories to the HCV unit via Home Accessory Controller:
HAC2 .
Replacement filters in sets of 2 standard filters or 1 standard plus 1 F7 (pollen) filter .
Installation of
accessories
Silencer
Electric preheating
VOC sensor
Hand-held remote
control (HRC 3)
HCP 10
HAC2 accessory
control
Filters
