Dantherm cdp 75, Service Manual

Page: 32 / 160

32
Mounting and installation instructions
Introduction
This section contains all necessary information for correct mounting of the dehumidifier.
The electrical installation is described at the end of this section.
Placing of
CDP 75/125/165
CDP 75, 125 and 165 can be placed in one of the following ways:
Placing Comments
Floor The dehumidifier can be placed directly on the floor.
Make sure that there is enough place for the drain outlet and the
water trap.
Footstands The dehumidifier can be placed on shock absorbing footstands.
The footstands are available as options on request.
Suspension
brackets The footstands are available as options on request.
When mounting the units onto a wall we recommend oscillation
dampers to be fitted between the unit and the suspension
brackets.
The suspension brackets are available as options on request.
Important •
When placing the dehumidifier, unimpeded access to the inspection door should be
ensured
•
When the unit has been mounted the handles are to be fixed to the inspection door
t
Condensate outlet
The condensate outlet is located on the air inlet side. The dehumidifier is delivered with
a 0,5 m water hose which is fixed to the 3/4” screw connector using the clip delivered
with the hose. The water hose is led to a drain.
Important •
The hose from the unit to the external drainage must have a fall of at least 2%
•
The drainage pipe has to be fitted with a water trap to prevent false air from getting
in through the pipe
•
As an alternative a condensate pump can be fitted at the water outlet to pump the
water to a drain
Continued overleaf