unDNEMO
User Manual
Attero Tech LLC 2016
Page 9
614-00030 Rev 02
When this mode is selected, the device will detect the USB connection and show “Connected to Host” on the display if
connected, and show “No Host Present” if no USB connection is present.
If Dante TX audio features are enabled within the unIFY Control Panel software for the unDNEMO, the USB playback audio
will be routed to the first and second Dante audio transmit channels of the device for stereo playback. Dante Controller
or another 3
rd
party application must be used to route the audio to the intended Dante receive device.
*NOTE:
The PC/Mac soundcard volume control will override the internal unDNEMO volume control. Prior to disconnecting
the USB connection, it is recommended that the volume be set to the maximum setting, such that the internal device
volume is not limited by the soundcard volume when the soundcard is not in use. Power cycling the unit will reset the
internal volume back to the soundcard volume defaults.
2.2.3 – Line Input Mode
The line input mode allows the user to connect a line-level analog audio
device to the rear panel 3.5mm TRS stereo analog input as an auxiliary
audio source.
Audio is routed from the line input as a mono mix to the internal speaker
or as a stereo source to connected headphones.
If Dante TX audio features are enabled within the unIFY Control Panel
software for the unDNEMO, the line input audio will also be routed to the first and second Dante audio transmit channels
of the device for audio bridging applications. Dante Controller or another 3
rd
party application must be used to route the
audio to the intended Dante receive device.
2.2.4 – All Input Mode
The all input mode allows the user to simultaneously monitor a mix of the
audio from the selected Dante network audio channel, the line level
analog input and the USB audio input. This is useful in applications that
require monitoring audio from multiple, independent sources
simultaneously.
Figure 10 - All Input Mode Audio Routing
In the All input mode, the USB, and Line input sources are indicated with a checkmark on the title bar of the display when
they are connected.
The main content area of the screen shows the channel name of the network input audio, with the active channel number
shown in the center of the title bar.
The channel Up/Down buttons are used to navigate the network audio channel selection just as they operate in the Net
Mode.
The All Input mode does not support any Dante TX audio routing capabilities.
Figure 8 – Brightness Control
Figure
9
– Brightness Control