Dante DNA1425T, Installation And Operation Manual, Page: 72 / 124

Parameter Function
Enable User need to check the box to enable motion detection function.
Working
Period
Here user may set arm/disarm period. Click on set button to open period
setup menu.
There are six periods every day for setup and user must check box in front of
each period to enable it.
Note: Period setup can be done by dragging mouse while not release left
mouse.
Anti-dither
System only memorizes one event during the anti-dither period. The value
ranges from 0s to 100s.
Area
Here user may set motion detection region and its sensitivity and area. (The
higher the sensitivity is, the easier to trigger motion detect; the smaller the
area, the easier to trigger motion detect.) The default covers all regions. User
must click on save before enabling user setup.
Record
Check it and so when alarm occurs, system will auto record. User shall set
record period in Storage>Schedule and select auto record in record control
interface.
Record Delay System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
Relay out Enable alarm activation function. User need to select alarm output port so
that system can activate corresponding alarm device when alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm ended. The
value ranges from 10s to 300s.
Send Email
If user enabled this function, System can send out email to alert user when
alarm occurs and ends. User can set email address in Network>SMTP.
Snapshot
User need to check the box here so that system can backup motion detection
snapshot file. User shall set snapshot period in Storage>Schedule.
Please refer to the following sheet for detailed information.
See Figure 5-28.
50