Page
10
of
28
B1 & B2 REAR PANEL LAYOUT
1. Network RJ45
The Neutrik Ethercon network socket can connect to both Neutrik Ethercon
and standard RJ45 cables. It is a 100M/bit standard IP network connection. The
status LED flashes to show when data is being correctly communicated
with the attached switch.
This is also how the device is powered using a Power Over Ethernet (PoE)
source. The PoE source can be a mid-span source or a network switch with PoE.
2. Headset connector
Headphone output
This 5 or 4 pin XLR socket accepts headphones from 30 to 1000 Ohms.
It has a unique headphone amplifier that allows it to provide the correct output
level regardless of the headphone impedance and it can also have mono
headphone jacks connected with no adverse effect.
Microphone Input
This is a balanced microphone input sharing the connector with the headphone
output. It can accept dynamic and condenser microphones and phantom power
(12v).
Refer to the end of this manual for wiring information.
3. Phantom power LED
This green LED will illuminate to indicate if +12v phantom power is active or
disabled.
3. Phantom power indicator
1. Network RJ45
2. Headset connector
