ENGLISH
7
ASSEMBLY INSTRUCTIONS
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. CONNECTING THE WHEELS TO THE LEGS
Parts Required:
1 x Support Leg / Front (#21)
1 x Support Leg / Back (#22)
1 x Support Leg for Wheel / Front (#23)
1 x Support Leg for Wheel / Back (#24)
2 x Locking Caster Wheel (#29)
2 x Wheel (#30)
2 x Wheel Cotter Pin (#E)
2 x Wheel Washer (#F)
2 x Wheel Axle Pin (#G)
Installation:
• Attach the Wheel to the Support Leg for Wheel by inserting the Wheel
Axle Pin through the Wheel, Support Leg hole, Wheel Washer, then
secure using the Wheel Cotter Pin. Repeat installation for the other
Support Leg with Wheel. Note 1A.
• Install a Locking Caster Wheel to the bottom of a Support Leg by
hand-tightening into the hole. The Locking Caster Wheel is inserted
completely when it cannot rotate any further into the Support Leg.
Repeat installation for second Support Leg. Note 1B.
Insert Locking Caster Wheel into the Bottom of left
front leg by hand-tightening into the hole. Ensure the
Locking Caster Wheel is inserted completely by
ensuring it cannot rotate any further.
Repeat installation for the other Locking Caster Wheel
and left back leg
ASSEMBLY PREPARATION
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack
after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before
assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to
assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Service for parts: Monday
through Sunday, 4am - 8pm PST (EN/FR/ES).
[email protected] | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly:
screwdriver, wrench and level.
Tools not included.
EX2
FX2
GX2
Attach the wheel to the support leg by inserting the wheel
axle pin through the wheel, support leg, wheel axle washer,
then secure using the wheel cotter pin.
Repeat installation for the other wheel and support
leg.
1A
A C B
Place a piece of cardboard on the floor to prevent
scratching the unit. Lay the main barrel on its side, hopper
end pointed upward, on the cardboard.
Mount one leg with wheel to the floor end of the main barrel
using three screws, locking washers, and washers, through
the three pre-drilled holes. Install screws from the inside
of the main barrel. Repeat installation for second leg with
wheel.
AX6
BX6
CX6
G
F E
30
23
24
1B
21
22
29
