Dannmar T-100, Installation And Operation Manual

Page: 13 / 56

16. Move the left hand top helper into position opposite the
mount/demount head positioning the edge of the helper just
outside the rim edge. (See Fig. 2-3)
17. Press down on the left hand control valve. (See Fig. 4)
18. Power the left top helper down to force the tire bead into
the drop the center of the wheel. (See Fig. 5-6)
19. Insert the smooth curved end of tool bar over the right
end knob of the mount/demount head and below the top
bead of the tire. (See Fig. 7 & 8)
20. Push the tool bar down toward the wheel to lift the tire
bead up and over the right -side knob portion of the demount
head. Hold the tool bar in this position.(See Fig. 9-10)
NOTE
This clearance will be maintained as long as the
slide lock remains locked. The operator may swing
the arm out of the way and back into place again
without needing to reposition the head when chang-
ing a like set of wheels. The tool clearance may
change with machine use and should be inspected
often. Failure to maintain proper clearance may
result in damage to the wheel rim or tire.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
13
Note:
The Following Procedures show
optional equipment being used;
The Tire Changer you are using may not have the
Assist Tower Option.