DLR-6/6P Low-Rise Scissor Lifts
18
P/N 5900254 — Rev. A — September 2020
Install the Wheels (DLR-6P only)
The DLR-6P comes with two Wheel Assemblies; they come assembled, but they must be installed on
top of the Wheel Brackets, which are located next to the Hinged Ramps.
Not necessarily to scale. Not all components shown.
To install the two DLR-6P Wheels
:
1.
Locate the two Wheel Assemblies and the eight Bolts/Split Washers/Nuts.
2.
Use a lifting device (such as a jack) to
raise
the Hinged Ramp end of the Lift up off the ground
approximately 6 in / 152 mm
and hold it up
.
3.
Put one of the Bolts into place through a Hole in the Wheel Bracket
from underneath
.
4.
Put a Wheel Assembly into place on top of the Wheel Bracket, then put a Split Washer and Nut
onto the Bolt Threads.
5.
Put the other three Bolts/Split Washers/Nuts into place and finger tighten the Nuts.
6.
Repeat Steps 3 through 5 for the other Wheel Assembly.
7.
Use an appropriate tool to
securely tighten
all of the Nuts and then lower the Hinged Ramp end of
the Lift back down to the ground.
Summary of Contents for DLR-6
