5
Receiver:
Insert a battery of the type LR6 or AA in the receiver.
2 green light means the battery level is low.
On/Off/Reset knob at the side of the receiver:
Upper position: On + Beep and light.
Middle position: On + Vibration and light.
Lower position: Off
Press the knob: Show last alarm. Next press reset the alarm.
When On show 3 red flash. If nothing more happens it is in standard mode.
If red and green light is added, the receiver is in Out Of Range mode.
When an alarm is received, the code of the transmitter (trigging) is shown
for eight seconds. After these eight seconds, the receiver gives a short indi-
cation every eight second, until the reset knob has been activated.
Press two times and the receiver is reset.
Coding of extra receiver:
In case a new receiver is bought, it has to be coded to the transmitter.
1. Press down the reset knob, when the receiver is pushed On. Three
flashes and sound or vibration will occur. Then the receiver will flash
quickly for five seconds.
2. When the receiver flashes quickly, release the reset knob.
3. Press down three times on the reset knob within the five seconds
during which the receiver flashes quickly.
4. Red light lights up permanently.
5. Within ten seconds, a call from the transmitter (trigging) shall be made.
6. If successful, the alarm from the transmitter is shown. If the coding
fails, green light is shown for one second.
Coding: Standard or Out Of Range -mode.
Press down the reset knob and turn on the receiver at the same time, until
three red lights have been shown. Now red light flashes quickly. Press three
times on reset knob. The red light continues, wait for ten seconds till the
green light has been shown. Now red light flashes quickly again. Press
three times at the reset knob and the receiver shows the mode. If standard
mode: No light. If “Out Of Range”: Green and red light is shown.
(Same procedure, but each second time it shifts mode)
