4
UK User Manual
In General:
danita APA100 is a pager system to be used both as a calling system and
an alarm system. The system consists of a transmitter with an antenna and
a receiver.
Four different indications can be transmitted. Thus it will be possible to
read directly from the receiver where the signals comes from. Depending
on the mounting you may e.g. be able to see if it is a door or the bonnet
which is being opened. In your home you can see which door is opened
and at the office you can see which room you will have to go to when you
are called for. Only your fantasy will set the limits to the possibilities of
applications.
Transmitter:
Wire connection and alarm call coding (trigging):
1. Red + 10-25 VDC (+ trig connect to + for action)
2. Black - (Chassis) (- trig connect to - for action)
3. Brown - trig. Green light at the receiver. (150mS trig time)
4. Grey - trig. Red light at the receiver. (450mS trig time)
5. White IGN. If connect to + DCV the transmitter is blocked.
After removing it takes 30 seconds before trig is active again.
6. Blue + trig. Yellow light at the receiver. (450mS trig time)
7. Green - trig. Yellow light at the receiver. (30mS trig time)
8. Yellow -trig. Alternating light. Yellow, green and red. (75mS trig time)
9 + 10. Orange. Out of range alarm. Gives quick shift with red and green
light. Attention: Set the receiver up for same mode.
Comes from factory in standard mode. Orange wire is intact.
If “Out Of Range” wanted, cut the orange wire.
From serial number E1001Rxxxxx.
Push knob on the transmitter box gives alternating light.
Mount the antenna to the BNC connector. The antenna should not be
mounted close to metal, as it will limit the transmitting range.
