P
I
02 9604 1226 E
I
|
danielaappliances.com.au
PA G E 1 1
INSTALLATION
The cooktop is to be installed as detailed below.
•
Remove any packaging, plastic film etc from appliance.
•
Before placing the cooktop in position fit the foam sealing strip on the underside, around
the perimeter. This will prevent spillage entering the cupboard under the hotplate.
•
DO NOT USE SILICONE WHEN INSTALLING YOUR COOKTOP.
THIS WILL VOID YOUR WARRANTY.
•
WHEN THE HOTPLATE IS INSTALLED ABUTTING A SIDE OR REAR WALL, THE WALL MUST
BE OF NON-COMBUSTABLE MATERIAL, e.g. CERAMIC TILES.
The following minimum clearances to combustible materials must be observed:
•
Minimum clearance from hotplate edge (Burner) to side wall must be 200mm
•
Minimum clearance from the hotplate (burner) edge to rear wall must be 200mm
•
Minimum clearance from the hotplate to cupboard above the hob burners must be minimum
of 600mm.
•
Range hoods and overhead exhaust fans must be installed according to the manufacturers’
instructions and AS5601, but in no case shall clearance from hob burners be less than
700mm for the range hood and 750mm for the overhead exhaust fan.
•
It is recommended that the adjacent kitchen surfaces should be capable of withstanding
temperatures of 100ºC.
•
Refer also AS5601 for installation requirements.
The hotplate must be secured to the bench using the supplied brackets to ensure hotplate
does not move.
Cut out dimensions (95GTG example only)
MODEL
WIDTH
DEPTH
95GTG
827mm
475mm
75GTG
552mm
474mm
64GTG
552mm
474 mm
865
475
510
827
