3
Figure depicts the Sensor Switch and the Manual ON/OFF Button
Maintenance
Routine service
Dan WL3 is maintenance free, but the following checks must be made annually:
1. Inspect the light for signs of damage or corrosion.
2. Press the on/off button and the light will commence flashing then press
the button once more and the light should deactivate.
3. To test the Sensor Switch
– a paper clip may be applied to the 2 water
contacts. It is recommended that the light is activated for 1 minute.
Replacement
The Dan WL3 lifejacket lights have a storage life of 5 years and must be replaced
by the date shown on the label.
Health and safety information
Dan WL3 lights contain Lithium cells. These must be handled correctly:
•
Do not dismantle the light assembly
•
Do not make any external electrical connection
•
Do not recharge
•
Do not incinerate
Store between -30°C and +65°C
The Batteries are hermetically sealed pressurised primary Lithium/Manganese
cells, and as supplied are electrically protected by a solid-state device and are
environmentally protected by a moulded plastic housing. In this condition the units
pose no definable hazard to health.
ON/OFF
Button
Sensor
Switch
