W W W . D A N G E R O U S P O W E R . C O M
18
19
velOCitY ADJustMent
• Locate the (1/8”) allen key wrench included with your FX.
• Adjust screw located at the bottom of Operating Pressure
Regulator (OPR) to increase or decrease velocity.
(SEE PIC A)
• Turn screw counterclockwise towards the (+) sign to
increase velocity.
(SEE PIC B)
• Turn screw clockwise towards the (-) sign to decrease
velocity.
WARNING
DP ENGINEERING RECOMMENDS THAT THE
VELOCITY NEVER EXCEED 300 FPS. FAILURE
TO FOLLOW REGULATIONS REGARDING
MAXIMUM ALLOWABLE VELOCITY,
CALCULATED IN FEET PER SECOND (FPS), MAY
RESULT IN DAMAGE OF PAINTBALL MARKER,
SERIOUS INJURY OR DEATH. BE RESPONSIBLE
AND ALWAYS USE A CHRONOGRAPH TO
DETERMINE ACCURATE VELOCITY BEFORE
PLAY.
tRiggeR ADJustMent
• Note the three adjustment screws (marked A, B, and C) in
the vicinity of the SWITCHBLADE
TM
Trigger.
• Screw A (5/64”) adjusts the amount of trigger travel prior
to the marker firing. Turning this screw clockwise will
reduce the amount of trigger travel. Turning this screw
counterclockwise will increase the amount of trigger
travel.
(SEE PIC A)
• Screw B (5/64”) sets the amount of trigger travel after the
marker has been fired. Turning the screw clockwise will
reduce the amount of trigger travel. Turning the screw
counterclockwise will increase the amount of trigger
travel.
(SEE PIC B)
NOTE
NOT TO TURN THE SCREW TOO FAR IN EITHER
DIRECTION, DOING SO MAY PUSH THE
TRIGGER PAST THE FIRING POINT AND CAUSE
OPERATIONAL FAILURE.
B
A
B
A