Expert configuration
Start-up Mode
Start CAN message output on WLAN side after link is established is selected by default. CAN
messages are then transmitted by means of WLAN while a TCP connection is established.
NMT Start-up Mode
When Enter operational mode automatically and send NMT start to all nodes is selcted a NMT start
message is sent to all CAN bus nodes (CAN open) when WS103 enters into Operational mode
(automatically at Start-up). By default, Enter operational mode automatically is selected. The device is
set to go automatically in operational mode without send the broadcast message over the network.
Performance Parameters
The following parameters value can be defined:
•
CAN receive loops per cycle
•
Wireless receive loops per cycle
Both parameters are set by default to 1024.
User Manual
WS103 Remote Solution
WS Wireless configurator
©
Danfoss | July 2016
AN00000339en-US0101 | 29
