Danfoss VLT, Programming Manual

Page: 125 / 231

20-02 Feedback 1 Source Unit
Option: Function:
[173] ft WG
[174] in Hg
[180] HP
NOTE
This parameter is only available when using pressure to
temperature feedback conversion.
If the choice Linear [0] is selected in
20-01 Feedback 1
Conversion , then the setting of any choice in 20-02 Feedback
1 Source Unit does not matter as conversion will be one-to-
one.
20-03 Feedback 2 Source
Option: Function:
See 20-00 Feedback 1 Source for
details.
[0]
*
No function
[1] Analog input 53
[2] Analog input 54
[3] Pulse input 29
[4] Pulse input 33
[7] Analog input X30/11
[8] Analog input X30/12
[9] Analog Input X42/1
[10] Analog Input X42/3
[11] Analog Input X42/5
[15] Analog Input X48/2
[100] Bus feedback 1
[101] Bus feedback 2
[102] Bus feedback 3
20-04 Feedback 2 Conversion
Option: Function:
See 20-01 Feedback 1 Conversion for
details.
[0]
*
Linear
[1] Square root
[2] Pressure to temperature
[3] Pressure to flow
[4] Velocity to flow
20-05 Feedback 2 Source Unit
Option: Function:
See 20-02 Feedback 1 Source Unit for details.
20-06 Feedback 3 Source
Option: Function:
See 20-00 Feedback 1 Source for
details.
[0]
*
No function
[1] Analog input 53
[2] Analog input 54
20-06 Feedback 3 Source
Option: Function:
[3] Pulse input 29
[4] Pulse input 33
[7] Analog input X30/11
[8] Analog input X30/12
[9] Analog Input X42/1
[10] Analog Input X42/3
[11] Analog Input X42/5
[15] Analog Input X48/2
[100] Bus feedback 1
[101] Bus feedback 2
[102] Bus feedback 3
20-07 Feedback 3 Conversion
Option: Function:
See 20-01 Feedback 1 Conversion for
details.
[0]
*
Linear
[1] Square root
[2] Pressure to temperature
[3] Pressure to flow
[4] Velocity to flow
20-08 Feedback 3 Source Unit
Option: Function:
See 20-02 Feedback 1 Source Unit for details.
20-12 Reference/Feedback Unit
Option: Function:
See 20-02 Feedback 1 Source Unit for details.
20-13 Minimum Reference/Feedb.
Range: Function:
0.000
ProcessCtrlUnit
*
[-999999.999 -
par. 20-14
ProcessCtrlUnit] Enter the desired minimum
value for the remote
reference when operating
with
1-00 Configuration Mode
set for Closed Loop [3]
operation. Units are set in
20-12 Reference/Feedback
Unit
.
Minimum feedback will be
-200% of either the value set
in
20-13 Minimum Reference/
Feedb. or in 20-14 Maximum
Reference/Feedb. , which ever
numeric value is the highest.
NOTE
If operating with 1-00 Configuration Mode set for Open Loop
[0], 3-02 Minimum Reference must be used.
Parameter Description
VLT
®
HVAC Drive Programming Guide
124 MG.11.CB.02 - VLT
®
is a registered Danfoss trademark
3 3