6.4.2 Oil Grade
Standard oils comply with DIN 51502 and DIN 51517 and are suitable for lubricating the gear unit. Food grade oils, which
comply with NSF H1, can be used.
The oil must permit low-friction, wear-free continuous operation. The damage load level on the FZG test as specified in
DIN 51354 should be in excess of load level 12, and the specific wear below 0.27 mg/kWh. The oil should protect against
corrosion and should not foam or attack the interior paint, the rolling contact bearings, gearwheels, or seals.
Do not mix different oil types since this may impair the characteristics of the oil. A long service life is only ensured by the
use of oil listed in
or an equivalent.
If the OneGearDrive is stored for a long period before installation, refer to
Only the following wear-protecting EP gear oils fulfill the requirements for the specified maintenance intervals (see
):
Oil manufacturer
Standard oil
Synthetic oil
PGLP 220
Food grade oil
NSF
USDA H1 oil
ARAL
Degol GS 220
Eural Gear 220
BP
Enersyn SP-XP 220
–
CASTROL
Alphasyn PG 220
OPTIFLEX A 220
OPTILEB GT 220
FUCHS
Renolin PG 220
Cassida Fluid GL 220
KLÜBER
Klübersynth GH 6-220
Klüberoil 4UH1-220N
MOBIL
Glygoyle HE 220
Glygoyle 30
SHC Cibus 220
SHELL
Omala S4 GX 220
–
TEXACO
–
NEVASTANE SL220
Table 6.4 Oil Grades
Maintenance, Diagnostics an...
Instruction Manual
MG75C422
Danfoss A/S © 08/2014 All rights reserved.
21
6
6
