117 of 132
M-SV-001-EN Rev.E
17. Apply thin coating of dielectric grease to
the underside of bearing power feed through
gaskets. See Figure 102 (Dielectric Grease Under
Gasket).
Figure 102 - Dielectric
Grease Under Gasket
18. Install the greased neoprene gaskets over the
feed through pins.
19. Clean off excess grease.
20. Using a lint-free rag, carefully wipe off any
dielectric grease from the exposed power feed
through pins.
21. Apply a thin coating of dielectric grease to
the PWM harness connectors (female) as shown
in Figure 103 (PWM Connectors) and clean off
any excess grease.
Figure 103 - PWM
Connectors
22. Apply dielectric grease to all of the feed
through 4-pin and 6-pin screws.
Figure 104 - Dielectric
Grease on Screws
Maintenance
NOTE
This process is not used for Major Revision “F” and later compressors with Molex connectors as shown in Figure 76 (Bearing PWM
Amplifier)
Summary of Contents for Turbocor TG230
