Danfoss TP5001 series, User Manual

Page: 5 / 104

5
U
ser Instruc
tions
GB
Changing the preset programmes
Before you change the preset programmes
Your installer will have set the unit to operate in one of the following
modes:
•
5/2 day - one set of programmes for weekdays and another for
weekends (page 5-6).
•
24 hr - one set of programmes for the whole of the week (page 6).
Alternatively
•
A/B - The unit can also be set by you to provide two programme
blocks, either of which can be applied to diff erent days of the week.
If this is required refer to page 6 for instructions on how to turn on
this feature.
Please Note
The unit must be programmed in sequence, event times cannot be
set out of sequence.
If you want to leave a preset time as it is, simply press PROG to
move to the next setting.
If you want to return the unit to RUN , press PROG and hold until
the colon in the display blinks. Alternatively leave alone and the
unit will automatically return to
RUN after 2 minutes.
Your installer will have set your unit to programme 6, 4 or 2 events
per day. This will determine the number of events per day that you
are able to programme.
Changing the preset programmes in 5/2 day mode
For Days 1-5 (weekdays)
a) Press PROG until the fi rst preset time and
temperature (Event 1 Days 1, 2, 3, 4, 5) appears
in display.
b) Use the + and - buttons to adjust the TIME
(press and hold to change in 10 minute increments).
c) Use the Λ and V buttons to adjust the required TEMPERATURE .