7. Safety notes
7.1 Conformity
with standards
7.2 Battery
This device conforms to the Low Voltage Directive (Safety) 73/23/EEC as per EN 60950 Safety of
Information Technology Equipment
Please note!:
Product safety is guaranteed only when power is supplied to the device via a power source/adaptor
approved according to EN60950-1, see section 2.5, and which does not exceed the given values.
The Danfoss Bluetooth® gateway is powered by a rechargeable Li-ion battery.
Temperature extremes can affect the ability of your battery to charge and can reduce the capacity and
lifetime of the battery.
Therefore, do not leave the gateway with battery in vehicles, direct sunlight, or other places where the
temperature may rise above 60⁰C or fall below 0⁰C.
Use the battery only for its intended purpose.
Do not expose the battery to water or extreme moisture.
Do not drop the battery or subject it to mechanical shocks.
Never use any charger or battery which is damaged.
Charge the battery after purchasing or when it has not been used for a long time.
The time required for full re-charging is approximately 2 hours.
Batteries should be charged in the original manufacturer´s Li-ion specified charging equipment. Use of
other chargers may cause excessive heat or even fire.
Do not open the gateway. Do not short-circuit the battery.
The battery should be replaced by authorized personnel only. Caution: Risk of explosion if battery is
replaced by an incorrect type.
Please contact your dealer / manufacturer for service information.
Do not dispose of batteries in a fire! Dispose of batteries according to local regulations
(e.g. recycling).
Do not dispose of as household waste.
Operating Instructions
Danfoss Bluetooth® Gateway with Tool4Cool® LabEdition
19
DEHC.PS.300.D1.02