manualshive.com logo in svg

Danfoss MCD LCP 501, Instructions, Page: 4 / 4

Share
Download
Danfoss MCD LCP 501 Instructions Download Page 4

Instructions: Control Panel LCP 501 

MI.17.G1.02 - VLT is a registered Danfoss trademark 

 

6.

 

Mounting template 

Drill four mounting holes for screws (one in each corner) and two holes for 
the DB9 connector.   

12

.7

 m

m

17

7H

A

613

.10

25 mm diameter

25 mm

13 mm

136 mm

4 mm diameter

 

Summary of Contents for MCD LCP 501

Page 1: ... metres away from the soft starter allowing remote control and monitoring The LCP is rated IP65 when mounted correctly in accordance with these instructions 2 Packing List 1 x LCP 4 x M3 x 16 Screw 1 x Cable DB9 3 metres 4 x M3 Flat washer 1 x Gasket foam 4 x M3 Spring washer 1 x Instruction sheet 4 x M3 Nut 2 x Jack screw 3 Specifications Maximum cable length 3 metres Protection IP65 and NEMA12 ...

Page 2: ...CD5 1600 The bus bar and or heatsink are live whenever mains voltage is connected Remove mains and control voltage from the soft starter before removing the cover 1 Use the template to drill four mounting holes and two holes for the DB9 connector 2 Apply the foam gasket to the back of the LCP 3 Align the LCP over the holes and screw in place 177HA614 10 4 Plug the cable into the LCP and the soft s...

Page 3: ...ly been used with a MCD 500 the operator can select whether to copy the parameters to the starter or to copy the MCD 500 s parameter settings into the LCP Select the required option using the and buttons The selected option is surrounded by a dotted line Press OK to proceed with the selection Copy Parameters Display to Starter Starter to Display If the parameter software version in the LCP is diff...

Page 4: ...501 MI 17 G1 02 VLT is a registered Danfoss trademark 6 Mounting template Drill four mounting holes for screws one in each corner and two holes for the DB9 connector 12 7 mm 177HA613 10 25 mm diameter 25 mm 13 mm 136 mm 4 mm diameter ...

Reviews:

No comments