Danfoss MCD LCP 501, Instructions, Page: 3 / 4

Instructions: Control Panel LCP 501
MI.17.G1.02 - VLT is a registered Danfoss trademark
5. Synchronising the LCP and the Starter
The DB9 cable can be connected/disconnected from the LCP while the starter
is running.
The first time a LCP is plugged into a starter, the
starter will copy its parameter settings to the LCP.
New Display Detected
If the LCP has previously been used with a MCD 500, the operator can select
whether to copy the parameters to the starter, or to copy the MCD 500's
parameter settings into the LCP.
Select the required option using the and
buttons. The selected option is surrounded by a
dotted line. Press OK to proceed with the
selection.
Copy Parameters
Display to Starter
Starter to Display
If the parameter software version in the LCP is different from the software
version of the starter, only
Starter to Display
will be available.
While the LCP is synchronising, only the OK and OFF buttons are
enabled.