© Danfoss | DCS (ms) | 2020.05
8 | AN317523977313en-000201
Password: 12131400
In Service menu a unique
password for Service menu
can be entered.
- Go to menu upper right
- Go login
- Go to settings
- Go to Service Password
- Enter new Service Password
Configuration continued
For further documents (Data sheet, SIL2 safety manual etc.) scan this QR code:
Danfoss A/S, 6430 Nordborg, Denmark
www.danfoss.com
LLS 007
7
8
Read and apply safety instructions contained in product documentation.
Direct current.
General warnings/precautions
- Every use that is not described in this guide is considered incorrect and is not authorized by the manufacturer.
- The LLS device should only be used with approved media listed under
General specifications
. Use with other medias must be
validated by Danfoss before installation.
- Verify that the installation and operating conditions of the device respects those specified in this guide, especially concerning
the supply voltage and environmental conditions.
- All service and maintenance operations must be performed by qualified personnel.
- Installation must comply with local standards and legislation.
- Before carrying out any maintenance operations on the device, disconnect the device from the main power supply.
- Before unscrewing the LLS device from the pipe or tank ensure that pipe or tank is empty and not under pressure.
- Liability for injury or damage caused by incorrect use of the device lies solely with the user.
- Depending on the application, the metallic part of the instrument may be hot or cold.
- If media detection or non-detection by the level switch could generate a hazard the SIL version and specific instructions described
in the safety manual (periodic proof test) should be used. The SIL safety manual can be downloaded from Danfoss web site or by
scanning the QR code below.
LLS 007
7
8
LLS 007
7
8
22
