1
VQIDC202 © Danfoss 12/2014
Quick Guide
living connect® Z,
Electronic Radiator Thermostat
Preparation
living connect® Z
is an electronic radiator thermostat, intended
for use with water based room radiators. It can be controlled by
a Z-Wave certi
fi
ed controller, which supports the appropriate
command classes.
Z-Wave
controller
living connect® Z
sensor
living connect® Z
is supplied with adapters for Danfoss RA valves
and valves with M30 x 1.5 (K) connections, two alkaline AA bat-
teries and a 2 mm Allen key.
Inserting the batteries
Remove the battery cover and insert two AA
batteries. Make sure the batteries are correctly
oriented.
Rechargeable batteries must not be used.
When replacing batteries the programme set-
tings will be preserved, but after two minutes
the settings for time and date are reset.
Installing
living connect® Z
M
must be
fl
ashing on the display prior to installing.
1. Start by mounting the ap-
propriate adapter.
RA
K
2. Tighten RA adapter using the
Allen key, hand-tighten the K
adapter (max. 5 Nm).
3. Screw the thermostat onto
the adapter and tighten by
hand (max. 5 Nm).
4. A large
M
fl
ashes, press
to
fi
x the thermostat.
Including the device to a network
Z-wave
controller
• Ensure
living connect® Z
is factory reset.
• Activate “Inclusion” on the Z-Wave controller.
• Quickly press and release
on
living connect® Z
.
• Observe both controller and
living connect® Z
for status of the
process.
Testing the connection
Press
for at least 3 seconds until
M
is displayed.
Press until
LI
is displayed.
Press
to test the connection.
LI
disappears when the connection is made.
If no connection can be made, the alarm symbol
and the antenna symbol
fl
ashes.
Display and buttons
Battery symbol
The set temperature
Network connection
Lock
Alarm
Use
to navigate the display and the menus and to set the
temperature, and use
to select and con
fi
rm.
