4
Installation
Remove wallplate from unit by unscrewing the two
screws on the bottom edge of the unit.
From the top left hand corner of the wallplate, there
must be clearances of at least 140 mm to the right,
15mm to the left, 30mm above and 100mm below in
order to mount the plug-on module.
The wallplate must be securely mounted either directly
to the wall using suitable wood screws or to a
fl
ush
mounted 1-gang electrical accessory box using M3.5
screws.
Cable access can either be from behind for concealed
cabling, or from below for surface cabling. If surface
cable is used, cut out cable access slot on plug-on
module prior to mounting the module.
For wiring connections refer to diagram on page 5.
FP715 models are double insulated and do not require
an earth connection, however a parking terminal is
provided on the wallplate. This is clearly marked with
an Earth symbol.
Prior to mounting the plug-on module, DIL switches
on the rear of the plug-on module must be set. See
diagram on page 5 for available options.
Mount plug-on module to wallplate by locating tabs on
top of wallplate in apertures on rear of module, hinge
down and press
fi
rmly to wallplate before tightening
securing screws on bottom of wallplate.
Installation
