Danfoss ET6200, Operator'S Manual

Page: 20 / 42

4.2 Intermediate storage of machine/unit
If the machine/unit cannot be mounted immediately upon delivery, it
must be protected against:
•
Contamination,
•
Weather influences,
•
Mechanical damage.
The machine/unit components may only be stored in closed rooms
and under the following conditions:
•
temperature between 10°C and 35°C,
•
maximum air humidity 80% (non-condensating).
4.3 Commissioning
The machine is commissioned by the customer's fitter.
1. Place the machine onto the optionally supplied table.
2. Bolt the machine on the bench.
Place the machine in a way so that it is easily accessible for main-
tenance work from all sides.
3. Check the machine for damage.
4. Check the compressed-air hoses for damage.
5.
Train the operating staff and record training sessions in “Decla-
ration of trained staff”, Section 9.
WARNING!
Risk of injuries!
Machine components might loosen during transport. Such com-
ponents might be flung out during the nipple insertion process.
There is a risk of being injured.
• Simulate the nipple insertion process several times without a
work piece.
• Check the machine for atypical noise.