•
Regularly check lines and bolted connections for leaks and
visible damage. Immediately remedy any damage detected.
Repair work on the hydraulic system of the machine/unit or on its
components may only be performed by UNIFLEX specialist staff.
2.3.4 Risks imposed by noise
The noise level meter acc. to IEC 804, Class 2, was calibrated be-
fore measuring.
The operation of the machine/unit causes noise emissions of < 70
dB(A) at the workplace. Noise protection is not required.
Higher noise emissions may occur when other machine/unitry is
simultaneously used at the workplace. The machine/unit owner
must provide for appropriate protection, e.g.
•
instruct staff to wear ear protection,
•
provide information/instructions on risks,
•
identify hazardous areas,
•
provide health monitoring.
2.3.5 Risks imposed by substances
Oils, greases and emulsions may penetrate the skin. When hand-
ling hazardous substances, oils and greases, the manufacturers'
safety instructions have to be observed. Apply skin protection ap-
propriate for the hazardous substances used.
2.3.6 Risk by hot surfaces
There is a risk of burning when touching the workpiece after for-
ming.
•
Wear protection gloves.
2.3.7 Risks in case of fire
The operating staff has to be familiar with the location as well as
with operating the fire alarm and fighting means. Free access to
this equipment must be ensured.
Summary of Contents for ET4400
