15
m
m
(0
.5
9
In
ch
)
1
2
3
4
5
6
7
cc-0048
1
2
3
4
5
6
7
Tightening torque 15 Nm
HM 8 bolt (4 pcs)
Lock washer (4 pcs)
Flat washer (4 pcs)
Steel mounting sleeve (4 pcs)
Rubber grommet (4 pcs)
Nut (4 pcs)
Figure 23: Rubber grommets from kit 8156138
1
CC
-0
00
00
01
Figure 24: Rubber grommets
27
.5
m
m
(1
.0
8
in
ch
)
CC-0049
2
8
3
4
5
6
7
1
2
3
4
5
6
7
8
The grommets must be compressed until contact between the flat washer and the steel mounting sleeve is
established. The required bolt size for the DSF090-200 compressors is HM8-40. This bolt must be tightened to a
torque of 15Nm.
Figure 22: Rubber grommets
Part 2, 3, 4, 5, 6 and 7 are delivered along with
compressor
Single requirements, DSF270-325-485-530 mounting
To be used in single applications, an additional accessory including flexible grommets is necessary kit 8156138.
The grommets must be compressed until contact between the flat washer and the steel mounting sleeve is
established. The required bolt size for the DSF compressors is HM8-55. This bolt must be tightened to a torque of 21
Nm.
Rubber grommets from kit 8156138
HM 8 bolt
Lock washer
Flat washer
Steel mounting sleeve
Rubber grommet
Nut
Compressor base plate
Manifolding requirements DSF 180E-400E and DSF285U-305U-330U mounting
The compressors must be mounted with rigid mounting spacers on rails. Rubber grommets and spacers must be
installed below the rails.
The rigid mounting spacers are included in tandem accessory kits. The rubber grommets are supplied with
compressor.
For more details about parallel mounting feet, please see parallel unit outline drawing.
© Danfoss | Climate Solutions | 2023.06
AB309735209512en-000603 | 23
Scroll compressors, DSF090 to DSF530 | Mechanical connections