Danfoss DGS Series, User Manual, Page: 11 / 24

User Guide
|
Danfoss Gas sensor. Type DGS. Modbus or Service Tool display operation
© Danfoss | DCS (ADAP-KOOL®) | 2018.12
RS8KD102 | 11
4.4
Menu Measuring Values
In this menu, the display shows the measuring
value with gas type and unit.
Measuring Values D 1 CO2 ppm
A ! 450
Symbol Description Function
D1 Actual Modbus address D1: Modbus address = 1
CO2 Gas type Display of gas type (must comply with gas type of sensor head)
ppm Gas unit Unit
51.0 C Measured value Current measured value (current value) of the gas concentration
A! Alarm indication At least one alarm has been released at this Measuring Point
# Maint. info Sensor head: maintenance due (maintenance date exceeded)
? ConfigError Gas type or meas. range doesn’t agree with sensor head.
Comm. err. Fault Measuring Point Communication error, sensor head <> I/O board
Underrange
Overrange
Meas. range monitoring
Meas. signal < admissible range (< zero point – 6 %)
Meas. signal > admissible range (> full scale value + 6 %)
Locked Measuring Point locked Measuring Point was temporarily locked by the operator.
Warm-up Warm-up time Warm-up time of the sensor active
Selection of the next measuring point
4.5
Display Parameters
In the menu Display Parameters you can find the
general parameters of the display.
Display
Parameters
4.5.1
Software Version
Software Version
XXXXX - YYYYY
Software version of the handheld Service Tool
and of DGS.
Symbol Description Function
XXXXX Software Version of the Service Tool XXXXX Software Version
YYYYY Software Version of the DGS YYYYY Software Version