EN
Drawing
Designation
Tools
Beginning at the middle of the heat shrink
tube, shrink the tube at a temperature
275 °F / 135 °C towards the ends of the heat
shrink tube.
Heat gun /
heating fan
Make sure that the glue is running from
both ends of the heat shrink tube. Now the
assembly is finished.
Sealing the and of the heating cable
Drawing
Designation
Tools
15
- Outer sheath removed
- Aluminum foil removed
- Drain wires removed
- Insulated matrix, cut at an
angle of approximately 45° on
the flat side to remove some
of one of the conductors. This
is to obtain sufficient distance
between conductors.
Cut 15 mm of the outer sheath, and cut off
the aluminum foil and drain wires from the
15 mm stripped cable too.
Cut insulated matrix at an angle of
approximately 45° on the flat side to remove
some of one of the conductors. Be careful
not to damage the insulation.
Wire cutter,
knife and tape
measure
1
5
- 20 mm small heat shrink tube is
put on over the end of the heat-
ing cable. 5 mm must still be
free of the cable
Now, put the 6/1,4 heat shrink tube (Length =
20 mm) over the end of the cable to the edge
of the removed outer sheath. 5 mm of the
crimp tube must still be free of the cable.
1
5
- 5 mm of small heat shrink tube
is squeezed while still hot. Press
flat with a flat pliers
Beginning at the middle of the heat shrink
tube, shrink the tube at a temperature
275 °F / 135 °C towards the ends of the heat
shrink tube. Im mediately after this the 5 mm
are squeezed together on the end with a flat
pliers. Make sure that the glue is running out
from both ends of the crimp tube.
Installation Guide Connection kit - cable to cold lead + end termination (Pipeheat)
DEVI
12
