Danfoss Heating Solutions
VIUHM602
© Danfoss 03/2011
6
4. Mounting
4.1 Remote Controller has been installed (fig. 2)
When Remote Controller has been installed to Master Controller (see chapter 2), it can be
mounted on the wall by means of the back plate/docking station
. This makes it possi-
ble to connect Remote Controller to a 230 V power supply with the included transformer/
power supply plug
. When not in the docking station, Remote Controller is powered by
two AA Alkaline 1.5 V batteries.
• Before you place the back plate/docking station on the wall, verify the transmission to
Master Controller from the desired location by carrying out a link test (see chapter 3).
• Mount the back plate/docking station on the wall with the screws and wall plugs
.
• Connect the docking station to a 230 V power supply outlet by means of the trans-
former/power supply plug
.
• Place Remote Controller in the docking station
.
Note: To extend the transmission range of the CF2
+
system, up to three Repeater Units can be
installed in a chain (see fig. 4).
5. Menus
5.1 Rooms
Menu
Rooms:
Activate the
Rooms
menu to access a list of all rooms in the system.
5.1.1 Select room
Menu
Rooms
Select room:
From the
Rooms
menu, select the desired room. The
screen displays information about settings and actual temperatures:
Indicates that this room is included in an ongoing time program (see chapter 5.2).
Indicates that the room thermostat is running low on battery.
Indicates that the value set on the room thermostat is beyond the max./min. limita-
tions set by Remote Controller.
Indicates that the set temperature is above the actual tempe rature.
Indicates that the set temperature is below the actual temperature.
Instruction
CF-RC Remote Controller
