© Danfoss | Climate Solutions | 2023.09
AX452438944357en-000301 | 9
3 I Disassembly of the compressor
Preparation: Necessary tools
Pos. Tool
Size
1
2
3
4
Oil collection container
Spanner
Allen key
Needle-nosed pliers
> 10 Liter
SW 10, 13, 15, 17, 19, 24, 27
6 mm, 10 mm
Removal of the compressor from the refrigerant system
Removal of the compressor from the system, shut-off valves remaining on the compressor
- Extract the refrigerant from the system into a container that is approved for this refrigerant
- Evacuate the systems including the compressor
- Cut off the vacuum, humid air should not get into the system
- Close the shut-off valves on the suction and discharge side; then remove the compressor
- Close the suction and discharge line connection points on the system with plug
- Relieve the pressure before dismounting the compressor
Removal of the compressor from the system, shut-off valves for compressor remaining at the system
- Close shut-off valves on the suction and discharge side
- Extract the refrigerant from the compressor into a container that is approved for this refrigerant
- Evacuate the compressor
- Cut off the vacuum
- Remove the compressor from the system
- Close the suction and discharge shut-off ports on the compressor with plugs
Disassembly of compressor
The disassembly of the compressor is explained in separate steps on the following pages. The indicated parts list
positions refer to the spare parts lists, repair set lists, special accessories part lists and are available
online at
www.bock.de.
You can find the exploded drawing at the end of the maintenance manual.
