User Guide
BasicPlus
2
Room Thermostats
03/2015
VUCUA212
Danfoss Floor Heating Hydronics
3
The function consists of 2 programs:
P1
with 4 events in 5 days (Mon. Tue. Wed. Thu. Fri.)
P2
with 4 events in 2 days (Sat. Sun.).
P1:
Press to display Mo. Tu. We. Th. Fr.
P1, Event 1:
1. Use
<
or
>
to select the start time.
2. Press to accept the setting.
3. Use
<
or
>
to select the temperature.
4. Press to accept the setting.
P1, Event 2-4:
Repeat the Event 1 procedure for programming
Event 2-4.
P2:
Sa. Su. are now shown in the display.
P2, Event 1:
1. Use
<
or
>
to select the start time.
2. Press to accept the setting.
3. Use
<
or
>
to select the temperature.
4. Press to accept the setting.
P2, Event 2-4:
Repeat the Event 1 procedure for programming
Event 2-4.
The thermostat will continue the 4-event program based on the present time and day.
To set and change the room temperature temporarily:
1. Press
<
or
>
at any time to change the desired temperature value.
SET
is shown in the display.
2. When releasing the
<
or
>
, the display returns to showing the actual temperature. This temperature change is
only temporary and will be maintained only until the next programmed setting!
A default program provides timer control if the customer does not create own programs:
Days
Event 1
Event 2
Event 3
Event 4
Start time
Temp.
Start time
Temp.
Start time
Temp.
Start time
Temp.
Mon - Fri
6:30
20° C
(27° C)*
8:30
15° C
(25° C)*
16:30
20° C
(27° C)*
22:30
15° C
(25° C)*
Sat - Sun
7:30
20° C
(27° C)*
9:30
20° C
(27° C)*
16:30
21° C
(28° C)*
22:30
15° C
(25° C)*
* Floor temperature control mode.
7
Check Floor Temperature
• Press
M
and hold. Press
<
within 6 seconds.
•
flashes and the current floor temperature is displayed. Operate again, then exit (automatic exit after 6
seconds with no operation).
8
Child Safety Lock
• Press
M
and hold. Press
>
within 6 seconds to lock all buttons.
• Press again to exit the child safety lock.
9
Set Control Parameters
Press
M
button for 6 seconds to enter the parameter setting mode. Press
M
for parameter selection and set the
parameter range via
<
or
>
. Complete all adjustments.
To exit WT-P/PR, press , which is available for this purpose (automatic exit after 30 seconds with no operation).
To exit WT-D/DR, wait for automatic exit (30 seconds). The upper digits indicate the parameter number.
