1
M5 pem nut (24 total on base plate)
Illustration 1.8 M5 Pem Nut Dimensions on the Base Plate
Illustration 1.9 Vent Opening Dimensions for the Cover Plate
Installing the Back Panel Cover
Refer to
Illustration 1.10
for the following steps:
1.
Install a gasket (4) around each exhaust vent opening
on the back side of the mounting backplate (3).
2.
Install a duct spacer (5) onto each exhaust gasket
and secure with 6 M5 nuts. Torque to 5.1 N · m
(45 in-lb).
3.
Place a gasket (7) onto each exhaust duct spacer.
4.
Prepare the back panel cover. Refer to
Illustration 1.11
.
4a
Cut out the 2 exhaust vent openings in the
back panel. The openings must match to
the exhaust duct spacer openings.
4b
Drill the 8 screw holes around the vent
openings.
5.
Secure the back panel cover to the frame.
6.
Secure the back panel cover to the duct spacers with
8 M5x16 screws. Torque to 5.1 N · m (45 in-lb).
Installation Instructions
In-bottom/Out-back Cooling Kit for VLT®
Parallel Drive Modules
VLT® Series FC 102, FC 202, and FC 302
MI92L102
Danfoss A/S © 04/2016 All rights reserved.
9
