FAQ
Zpen User’s Guide
46
o
A: The receiver is not being charged; the computer may not be
providing enough current to charge the receiver. Therefore, replace the
USB port (or the USB extension cable) on your computer or try to
recharge it on a different computer.
-
Part of the text I wrote was not saved.
o
A: The receiver turned off due to a low battery level. Recharge the
battery.
-
How long do I need to charge the receiver’s battery?
o
A: Recharging an empty battery until it is full may take 5-6 hours.
-
How do I know when the receiver has finished charging?
o
A: While charging, the power on LED (left most LED) blinks. When it
stops blinking (turned on), the receiver is fully charged.
-
Is there an indication for “flash memory full”?
o
A: The right most LED starts blinking rapidly.
-
Do I need to replace the receiver’s battery?
o
A: No. The receiver’s battery is a rechargeable and capable of running
hundreds of charging cycles.
-
How do I know that I turned a page on the receiver?
o
A: Upon releasing the receiver’s clip, you will notice the pen LED
(middle LED) turning on for 0.5 seconds, indicating that a new page
has been opened.
-
Can I plug in the receiver into the computer without turning it off first?
o
A: Yes; however we recommend turning it off first.
-
All lights are on, and the receiver does not respond.
o
A: This might happen due to problems in the USB power or with the
connector’s contacts. Restart the receiver by pressing the reset button
on the back (small hole near one of the edges).
Pen
-
How do I know that the pen is transmitting?
o
A: When you start writing, the pen down LED (middle one) turns on
every time the pen tip touches the writing surface.
-
When writing, the pen down LED (middle LED) does not turn on.
