MASTER CONNECTORS
The master connector panel houses 12 RCA Cinch connectors, 2 jack sockets, and 2 male XLR connectors. The
electrical mains connector with integrated fuse holder is located in this section.
A ground terminal completes the back panel connector section.
TAPE OUTPUTS
The tape output connectors are left and right outputs for connecting to the inputs of a stereo audio recorder or
any other analog or digital device. Output level is -10dBv (300mV), the signal is pre master fader.
CLEANFEED OUTPUTS
Direct beneath the Tape outputs are the Clean feed RCA cinch output connectors.
RED LIGHT
Directly beneath the Clean feed RCA cinch connectors is a stereo jack socket (Mic On) that can control a red light
indicator. This stereo jack is connected to a change over relay. This relay is capable of controlling external Red light
circuits as long as it doesn’t take a higher voltage than 24 volt and the current doesn’t exceed 50mA!
NEVER CONNECT 120/220 AC VOLTAGE TO THIS JACK!!
The C.C. (Center Contact) of the internal relay is connected to the Tip of the stereo jack.
The N.O. (Normally Open) contact is connected to the ring of the jack.
The N.C. (Normally Closed) contact is connected to the “sleeve or ground” of the jack.
9. AIRMATE-USB RED LIGHT / START EXAMPLES
Start / Mic-On Jack
Function relais contact
Comment
Tip
CC (Center Contact)
Max. 24V, 50mA.
By jumper selection Pulls or Continue.
Ring
NO (Normal Open)
Sleeve
NC (Normal Close)
NOTE:
Our latest D&R ON-AIR warning light design does not need an external relay. Just 2 wires from the remote control
output jack (tip-ring) of your AIRMATE-USB to the barrier strip inside the ON-AIR lamp and that is it!
Summary of Contents for AIRMATE-USB
Page 1: ...AIRMATE USB MANUAL V 2 07 ...