- 3 -
Magnetic Mount
WARNING!
As with any magnetically mounted warning device, its use on the exterior of a moving vehicle is at
the sole discretion and responsibility of the user. Magnetic mount products provide a secure,
temporary installation in most circumstances and are recommended for STATIONARY USE
ONLY.
Rust stains: Magnetic mounting is not intended as permanent mounting for beacons. The device
should be removed when not in used to prevent rust stains.
1. Determine the mounting position of the LED beacon on a flat, metallic surface.
2. Before installing the beacon clean very well the mounting surface.
3. The magnet is factory assembled on the mounting plate. Route the beacon harness through the side
slot provided into the beacon’s base. Attach the mounting plate to the beacon’s base by matching the 3
mounting holes and using the #8-32-3/4” SS screws provided with the unit.
4. Place the beacon with magnet mount on a metal surface and plug it into a cigarette lighter outlet.
Check that the beacon device is stable on the mounting surface.
Wiring Connections:
RED – Connect to POSITIVE terminal of a +12V BATTERY through a SPST switch and a 5A fuse
BLACK – Connect to GROUND terminal of a +12V BATTERY.
WHITE – Connect to +12VDC through an ON/OFF SPST switch.
GREEN – Connect to GROUND through a Normally Open MOMENTARY switch.
Use min. 18GA wires