- 2 -
The use of emergency warning devices does not ensure the safety of the operator. The operator is
responsible to ensure safe operation of the vehicle regardless of whether the warning device is in
operation or not.
This device contains high-intensity LEDs. To prevent eye damage avoid prolonged exposure to
the light source and never look directly into the light.
If the product will have a temporary installation system, such us: magnetic, suction cup,
VELCRO® or tape, the mounting surface has to be cleaned with water mixed with isopropyl
alcohol or mild soap.
Do not use a pressure washer to clean this product. To clean the lens use only water and mild soap.
The use of stronger chemicals can affect the physical and optical characteristics of the outer lens,
resulting in cracks and/or discoloration/opacity of the lens.
The device must be installed so as not to reduce the output performance of vehicle systems.
When in use the operator must ensure that the warning signal is visible and not obstructed by
vehicle components (i.e. open trunk lid), people or other obstructions.
This device is intended for use by authorized personnel only. The user responsibility is to ensure
that all local, state/provincial and federal laws are being complied with. D&R assumes no liability
for any loss resulting from the use of this device.
Installation:
Permanent Mount
1.
Determine the mounting position of the LED beacon
2. Unscrew the 3 #4 stainless steel screws holding the bottom metal base together with the beacon. Keep
the screws, washers and lock washers in a secure place as they are needed later in the mounting process.
3. Locate the 2 mounting holes on the beacon metal mounting base and mark their location onto the
rubber gasket and onto the mounting surface. Locate and mark also onto the mounting surface the position
of the center hole used for the harness passage.
3. Drill the 2 marked mounting holes into the rubber gasket and into the mounting surface using an
appropriately sized drill bit. Drill the harness passage hole using a 3/8” drill bit. Clean all the holes from
any residues resulted from the drilling process. It is recommended to install a rubber grommet (customer
supplied) to protect the beacon harness when is passed through the mounting surface.
4. Place the rubber gasket onto the mounting surface aligning the 2 mounting holes. Place on top of the
gasket the metal mounting plate matching the 2 mounting holes with the ones from the gasket and the
mounting surface. Make sure that the gasket stays flat on the mounting surface.
5. Secure the metal mounting base and the gasket to the mounting surface with sheet metal screws.
5. Feed the beacon harness through the center hole of the plate, gasket and mounting surface passing hole.
Place the assembled beacon onto the mounting base lining up the 3 mounting holes with the holes in the
base plate. Secure the beacon to the mounting base with the 3 stainless steel screws removed in step 2.
6. Extend the wire harness to access the power source and refer to the next section in the manual for
wiring and operation.